Home › SUSPENSION & AXLE › SUSPENSION › REAR SHOCK ABSORBER

REAR SHOCK ABSORBER > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.
  3. A bolt without a torque specification is shown in the standard bolt chart (Click here).



1. INSTALL REAR SHOCK ABSORBER ASSEMBLY


C118720
  1. Install the 3 retainers, 2 cushions, bracket and a new lock nut to the shock absorber.

    Torque:
    20 N*m{ 204 kgf*cm , 15 ft.*lbf }

  1. Install the shock absorber to the frame with the 2 bolts.

    Torque:
    25 N*m{ 255 kgf*cm , 18 ft.*lbf }



2. TEMPORARILY INSTALL REAR SHOCK ABSORBER ASSEMBLY


C118719
  1. Install 2 new bushes and the 2 retainers to the shock absorber.

  1. Temporarily install the shock absorber to the axle housing with the nut.



3. INSTALL REAR WHEEL

Torque:
105 N*m{ 1,071 kgf*cm , 77 ft.*lbf }



4. STABILIZE SUSPENSION
  1. Lower the vehicle.

  1. Press down on the vehicle several time to stabilize the suspension.



5. TIGHTEN REAR SHOCK ABSORBER BOLT
  1. Tighten the bolt.

    Torque:
    82 N*m{ 816 kgf*cm , 60 ft.*lbf }