Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › REAR BLOWER MOTOR

REAR BLOWER MOTOR > INSTALLATION

for Preparation Click here



1. INSTALL REAR BLOWER MOTOR WITH FAN SUB-ASSEMBLY
  1. Install the rear blower motor with fan sub-assembly with the 3 screws.

  1. Connect the connector.



2. INSTALL QUARTER INSIDE TRIM BOARD RH
  1. Detach the 8 claws and 10 clips to install the quarter inside trim board.

  1. Install the clip.

  1. Connect the rear No. 2 seat outer belt floor anchor with the bolt.

    Torque:
    42 N*m{ 428 kgf*cm , 31 ft.*lbf }

  1. Connect the rear No. 1 seat outer belt floor anchor with the bolt.

    Torque:
    42 N*m{ 428 kgf*cm , 31 ft.*lbf }

  1. Attach the 2 claws to install the outer lap belt anchor cover.

    HINT:
    Use the same procedure for both outer lap belt anchor covers.



3. INSTALL QUARTER TRIM HOOK

HINT:
Use the same procedure for both quarter trim hooks.

  1. Install the quarter trim hook with the screw.



4. INSTALL BACK DOOR SCUFF PLATE
  1. Attach the 4 claws, 2 guides and 6 clips to install the back door scuff plate.



5. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP RH

HINT:
Use the same procedure described for the LH side.



6. INSTALL REAR DOOR SCUFF PLATE RH

HINT:
Use the same procedure described for the LH side.



7. INSTALL REAR NO. 2 SEAT ASSEMBLY
(Click here)