Home › BODY ELECTRICAL › WIPER AND WASHER › REAR WIPER MOTOR

REAR WIPER MOTOR > INSPECTION

for Preparation Click here



1. INSPECT REAR WIPER MOTOR ASSEMBLY


B117882E01
  1. Check the wiper operation.

    1. Connect the battery's positive (+) lead to terminal 1 (+) and the negative (-) lead to terminal 2 (-1), and check that the motor operates.

      OK:
      Motor operates.

      If the result is not as specified, replace the motor assembly.



  1. Check the automatic stop operation.

    1. Connect the battery's positive (+) lead to terminal 1 (+) and the negative (-) lead to terminal 2 (-1). With the motor rotating, disconnect terminal 1 (+) to stop the wiper motor operation at the automatic stop position.



    2. B117887E02
    3. Check that the motor stops automatically at the automatic stop position.

      OK:
      Refer to illustration.

      If the result is not as specified, replace the motor assembly.