BRAKE FLUID (w/o VSC) > BLEEDING |
| 1. FILL RESERVOIR WITH BRAKE FLUID |
| 2. BLEED AIR FROM BRAKE MASTER CYLINDER |
Using a union nut wrench, disconnect the 2 brake lines from the master cylinder.
![]() |
Slowly depress and hold the brake pedal.
![]() |
Cover the outer holes with your fingers, and release the pedal.
Repeat the 2 previous steps 3 or 4 times.
Using a union nut wrench, connect the 2 brake lines to the master cylinder.
| 3. BLEED AIR FROM LOAD SENSING VALVE BODY |
Remove the bleeder plug cap.
![]() |
Connect a vinyl tube to the bleeder plug.
Depress the brake pedal several times, and then loosen the bleeder plug with the pedal depressed.
When fluid stops coming out, immediately tighten the bleeder plug. Then release the pedal.
Repeat the 2 previous steps until all the air in the brake fluid is gone.
Tighten the bleeder plug.
Install the bleeder plug cap.
| 4. BLEED AIR FROM BRAKE LINE |
![]() |
Remove the bleeder plug cap.
Connect a vinyl tube to the bleeder plugs.
Depress the brake pedal several times, and then loosen the bleeder plug with the pedal depressed.
When fluid stops coming out, immediately tighten the bleeder plug. Then release the pedal.
Repeat the 2 previous steps until all the air in the brake fluid is gone.
Tighten the bleeder plug.
Install the cap.
Bleed air from the brake line for each wheel by repeating the above procedures.