Home › BRAKE › BRAKE › BRAKE PEDAL (w/o VSC)

BRAKE PEDAL (w/o VSC) > REASSEMBLY

for Preparation Click here



1. INSTALL BRAKE PEDAL PAD
  1. Install the pad to the pedal.



2. INSTALL STOP LIGHT SWITCH ASSEMBLY


C111301E01
  1. Install the adjuster to the support.

  1. Insert the switch into the adjuster until it slightly touches the pedal.

    NOTICE:
    Do not depress the pedal.



    C111302E01
  1. Turn the switch a quarter turn clockwise.

    Torque:
    1.5 N*m{ 15 kgf*cm , 13 in.*lbf }

    NOTICE:
    Do not depress the pedal.

  1. Check the switch clearance.

    Standard stop light switch clearance:
    1.5 to 2.5 mm (0.0591 to 0.0984 in.)



3. INSTALL BRAKE PEDAL SUB-ASSEMBLY


C213466E02
  1. Apply a light coat of lithium soap base glycol grease to 2 new bushes, the brake pedal shaft collar and shaft.

  1. Install the brake pedal shaft and 2 bushes to the pedal.

  1. Install the pedal to the support with the shaft and nut.

    Torque:
    26 N*m{ 265 kgf*cm , 19 ft.*lbf }