Home › BRAKE › BRAKE › BRAKE MASTER CYLINDER (w/o VSC)

BRAKE MASTER CYLINDER (w/o VSC) > REMOVAL

for Preparation Click here


NOTICE:
Make sure to release the vacuum from the brake booster before removing the master cylinder from the brake booster,



1. DRAIN BRAKE FLUID

NOTICE:
Wash off brake fluid immediately if it comes in contact with any painted surface.



2. REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY


    C121973E01
  1. for Manual Transmission:
    Disconnect the clutch reservoir tube labeled A from the master cylinder.

  1. Disconnect the brake fluid level warning switch connector labeled B.

  1. Using a union nut wrench, disconnect the 5 brake lines labeled C from the master cylinder and 3-way.



    C121974
  1. Remove the 2 nuts and bracket (with 3-way).

  1. Pull out the master cylinder from the brake booster.

  1. Remove the O-ring from the master cylinder.



3. REMOVE BRAKE MASTER CYLINDER RESERVOIR SUB-ASSEMBLY
  1. Remove the screw.

  1. Remove the reservoir and 2 grommets from the master cylinder.