BRAKE MASTER CYLINDER (w/ VSC) > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. DRAIN BRAKE FLUID |
| 3. REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY |
![]() |
for Manual Transmission:
Disconnect the clutch reservoir hose from the master cylinder reservoir.
Disconnect the brake fluid level warning switch connector.
Using a union nut wrench, disconnect the 4 brake lines from the master cylinder and brake tube way.
![]() |
Remove the 2 nuts and brake tube way.
Pull out the master cylinder from the brake booster.
Remove the O-ring from the master cylinder.