Home › BRAKE › BRAKE › BRAKE MASTER CYLINDER (w/o VSC)

BRAKE MASTER CYLINDER (w/o VSC) > REMOVAL

for Preparation Click here


NOTICE:
Make sure to release the vacuum from the brake booster before removing the master cylinder from the brake booster,



1. DRAIN BRAKE FLUID

NOTICE:
Wash off brake fluid immediately if it comes in contact with any painted surface.



2. REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY


  1. for Manual Transmission:
    Disconnect the clutch reservoir tube labeled A from the master cylinder.


    C111293E04

  1. Disconnect the brake fluid level warning switch connector labeled B.

  1. Using a union nut wrench, disconnect the 5 brake lines labeled C from the master cylinder and 3-way.



  1. Remove the 2 nuts and bracket (with 3-way).


    C111294E02

  1. Pull out the master cylinder from the brake booster.

  1. Remove the O-ring from the master cylinder.