PARKING BRAKE CABLE > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE REAR WHEEL |
| 3. REMOVE REAR BRAKE DRUM SUB-ASSEMBLY |
Release the parking brake lever, and remove the drum and gasket.
![]() |
Remove the hole plug (adjust) and insert a screwdriver into the hole on the backing plate, and hold the automatic adjust lever away from the adjuster.
Using another screwdriver, compress the shoe adjuster by turning the adjusting wheel.
| 4. REMOVE CONSOLE BOX ASSEMBLY |
Remove the console box assembly (Click here).
| 5. REMOVE NO. 1 PARKING BRAKE CABLE ASSEMBLY |

Disconnect the cable from the parking brake lever (Click here).
Remove the 2 bolts and No. 1 heat insulator.
Remove the No. 1 clip and pin.
Disconnect the cable from the No. 3 cable.
Disconnect the cable from the equalizer.
Remove the bolt holding the cable.
Remove the cable from the cable support bracket.
| 6. REMOVE NO. 2 PARKING BRAKE CABLE ASSEMBLY |

Disconnect the cable from the parking brake shoe lever RH and backing plate RH.
Disconnect the cable from the lever (Click here).
Remove the 2 bolts and disconnect the cable from the backing plate.
Remove the 3 bolts and No. 2 heat insulator.
Disconnect the cable from the equalizer as shown in the illustration.
Remove the 4 bolts and cable as shown in the illustration.
| 7. REMOVE NO. 3 PARKING BRAKE CABLE ASSEMBLY |

Disconnect the cable from the parking brake shoe lever LH and backing plate LH.
Disconnect the cable from the lever (Click here).
Remove the 2 bolts and disconnect the cable from the backing plate.
Remove the No. 3 clip as shown in the illustration.
Remove the 4 bolts, nut and cable as shown in the illustration.