Home › BRAKE › PARKING BRAKE › PARKING BRAKE SYSTEM

PARKING BRAKE SYSTEM > ADJUSTMENT

for Preparation Click here



1. CHECK PARKING BRAKE LEVER TRAVEL
  1. Pull the lever upward with a force of approximately 200 N (20 kgf, 45 lbf) and count the number of clicks.

    OK:
    7 to 9 clicks (without rear brake dragging)



2. REMOVE PARKING BRAKE HOLE COVER SUB-ASSEMBLY


B278222
  1. Detach the 4 claws and remove the parking brake hole cover.



3. LOOSEN LOCK NUT AND NO. 1 WIRE ADJUSTING NUT


C112487E01


4. REMOVE REAR WHEEL


5. ADJUST BRAKE SHOE CLEARANCE


6. INSTALL REAR WHEEL

Torque:
105 N*m{ 1071 kgf*cm , 77 ft.*lbf }



7. ADJUST PARKING BRAKE LEVER TRAVEL


C112487E01
  1. Turn the No. 1 wire adjusting nut until the lever travel is correct.

    OK:
    7 to 9 clicks (without rear brake dragging)
    <Lever pulling force: approximately 200 N (20 kgf, 45 lbf)>

  1. Tighten the lock nut.

    Torque:
    5.2 N*m{ 53 kgf*cm , 46 in.*lbf }

    HINT:
    If further adjustment is necessary, proceed to the next step.



8. ADJUST PARKING BRAKE TURN BUCKLE


F050156E01
  1. Loosen the lock nut and turn buckle until the lever travel is correct.

  1. Tighten the lock nut.

    Torque:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf }



9. INSTALL PARKING BRAKE HOLE COVER SUB-ASSEMBLY
  1. Attach the 4 claws to install the parking brake hole cover.