Home › BODY ELECTRICAL › LIGHTING › LIGHTING SYSTEM

LIGHTING SYSTEM > LVL Terminal Circuit

for Preparation Click here


DESCRIPTION

  1. When terminals LVL and CG of the DLC3 are connected, the headlight leveling ECU initializes the height control sensor signal.

WIRING DIAGRAM


E227421E02


INSPECTION PROCEDURE

HINT:
After replacing the headlight leveling ECU, initialization of the ECU is necessary (Click here).

1.CHECK HARNESS AND CONNECTOR (DLC3 - HEADLIGHT LEVELING ECU ASSEMBLY)
  1. Disconnect the H17 headlight leveling ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    H17-5 (SPDL) - D3-8 (LVL)
    Always
    Below 1 Ω
    H17-5 (SPDL) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.CHECK HARNESS AND CONNECTOR (DLC3 - BODY GROUND)
C166029E49
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    D3-4 (CG) - Body ground
    Always
    Below 1 Ω

    Text in Illustration 
    *a
    Front view of DLC3



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE HEADLIGHT LEVELING ECU ASSEMBLY (Click here)