THEFT DETERRENT SYSTEM > Ignition Switch Circuit |

| 1.INSPECT IGNITION SWITCH ASSEMBLY |
![]() |
Remove the ignition switch assembly.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 1 (IG1) - 4 (AM1) | Off, ACC | 10 kΩ or higher |
| 1 (IG1) - 4 (AM1) | ON, START | Below 1 Ω |
| Result | Proceed to |
| OK | A |
| NG (for 1GR-FE) | B |
| NG (for 2TR-FE) | C |
| NG (for 1KD-FTV) | D |
| NG (for 2KD-FTV) | E |
|
| ||||
|
| ||||
|
| ||||
|
| ||||
| A | |
| 2.CHECK HARNESS AND CONNECTOR (THEFT WARNING ECU - BATTERY AND BODY GROUND) |
![]() |
Disconnect the T36 theft warning ECU assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| T36-1 (E) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| T36-4 (IG) - Body ground | Ignition switch OFF | Below 1 V |
| T36-4 (IG) - Body ground | Ignition switch ON | 11 to 14 V |
| *a | Front view of wire harness connector (to Theft Warning ECU Assembly) |
|
| ||||
| OK | ||
| ||