Home › SECURITIES › THEFT DETERRENT › THEFT DETERRENT SYSTEM

THEFT DETERRENT SYSTEM > Security Horn Circuit


DESCRIPTION

When the theft deterrent system is operating, a relay in the theft warning ECU assembly turns ON and OFF continuously at 0.4 second intervals, causing the security horn to sound.

WIRING DIAGRAM


B275964E05


INSPECTION PROCEDURE

NOTICE:
When replacing the theft warning ECU assembly, refer to the registration procedures (Click here).

1.INSPECT SECURITY HORN ASSEMBLY
B119759
  1. Remove the security horn assembly.

  1. Apply battery voltage to the horn and check the operation of the horn.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 1
    Battery negative (-) → Horn bracket
    Horn sounds



NG
REPLACE SECURITY HORN ASSEMBLY
OK


2.CHECK HARNESS AND CONNECTOR (THEFT WARNING ECU - SECURITY HORN)
  1. Disconnect the T36 theft warning ECU assembly connector.

  1. Disconnect the S1 security horn assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    T36-26 (SH-) - S1-1
    Always
    Below 1 Ω
    T36-26 (SH-) or S1-1 - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE THEFT WARNING ECU ASSEMBLY