THEFT DETERRENT SYSTEM > Security Indicator Light Circuit |

| 1.INSPECT SECURITY INDICATOR LIGHT ASSEMBLY |
![]() |
Remove the security indicator light assembly.
Apply battery voltage between the terminals of the security indicator light assembly, and check the illumination of the security indicator light assembly.
| Measurement Condition | Specified Condition |
| Battery positive (+) → Terminal 2 Battery negative (-) → Terminal 1 | Illuminates |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (SECURITY INDICATOR LIGHT - THEFT WARNING ECU AND BODY GROUND) |
Disconnect the S10 security indicator light assembly connector.
Disconnect the T36 theft warning ECU assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| T36-22 (IND) - S10-2 | Always | Below 1 Ω |
| T36-22 (IND) or S10-2 - Body ground | Always | 10 kΩ or higher |
| S10-1 - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||