THEFT DETERRENT SYSTEM > Driver Side Door Courtesy Switch Circuit |

| 1.CHECK COMBINATION METER ASSEMBLY |
When the driver side door is opened/closed, check that the indicator in the combination meter assembly operates normally.
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (COMBINATION METER - THEFT WARNING ECU) |
Disconnect the C27 combination meter assembly connector.
Disconnect the T36 theft warning ECU assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| C27-17 - T36-7 (CTY) | Always | Below 1 Ω |
| C27-17 or T36-7 (CTY) - Body ground | Always | 10 kΩ or higher |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| C27-17 - Body ground | Always | 11 to 14 V |
|
| ||||
| OK | ||
| ||
| 3.INSPECT FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY (FOR DRIVER SIDE) |
![]() |
Remove the front door courtesy light switch assembly (for Driver Side) (Click here)
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 1 - Body ground | Not pushed (ON) | Below 1 Ω |
| Pushed (OFF) | 10 kΩ or higher |
| *a | Not pushed (ON) |
| *b | Pushed (OFF) |
| *c | Body ground |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (COMBINATION METER - FRONT DOOR COURTESY LIGHT SWITCH [FOR DRIVER SIDE]) |
Disconnect the C27 combination meter assembly connector.
Disconnect the D4 front door courtesy light switch assembly (for Driver Side) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| C27-16 - D4-1 | Always | Below 1 Ω |
| C27-16 or D4-1 - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||