Home › SECURITIES › THEFT DETERRENT › THEFT DETERRENT SYSTEM

THEFT DETERRENT SYSTEM > Front Passenger Side Door Courtesy Switch Circuit


DESCRIPTION

The theft warning ECU assembly detects the condition of the front door courtesy light switch assembly (for Front Passenger Side).

WIRING DIAGRAM


B276107E31


INSPECTION PROCEDURE

1.INSPECT FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY (FOR FRONT PASSENGER SIDE)


    B276106E01
  1. Remove the front door courtesy light switch assembly (for Front Passenger Side) (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - Body ground
    Not pushed (ON)
    Below 1 Ω
    1 - Body ground
    Pushed (OFF)
    10 kΩ or higher

    Text in Illustration 
    *a
    Not pushed (ON)
    *b
    Pushed (OFF)
    *c
    Body ground



NG
REPLACE FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY (FOR FRONT PASSENGER SIDE) (Click here)
OK


2.CHECK WIRE HARNESS (FRONT DOOR COURTESY LIGHT SWITCH [FOR FRONT PASSENGER SIDE] - THEFT WARNING ECU)
  1. Disconnect the D5 front door courtesy light switch assembly (for Front Passenger Side) connector.

  1. Disconnect the T36 theft warning ECU assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    D5-1 - T36-7 (CTY)
    Always
    Below 1 Ω
    D5-1 or T36-7 (CTY) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)