Home › SECURITIES › THEFT DETERRENT › THEFT DETERRENT SYSTEM

THEFT DETERRENT SYSTEM > Rear Door Courtesy Switch RH Circuit


DESCRIPTION

The theft warning ECU assembly detects the condition of the rear door courtesy light switch assembly RH.

WIRING DIAGRAM


B276107E33


INSPECTION PROCEDURE

1.INSPECT REAR DOOR COURTESY LIGHT SWITCH ASSEMBLY RH
B276106E01
  1. Remove the rear door courtesy light switch assembly RH (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - Body ground
    Not pushed (ON)
    Below 1 Ω
    Pushed (OFF)
    10 kΩ or higher

    Text in Illustration 
    *a
    Not pushed (ON)
    *b
    Pushed (OFF)
    *c
    Body ground



NG
REPLACE REAR DOOR COURTESY LIGHT SWITCH ASSEMBLY RH (Click here)
OK


2.CHECK HARNESS AND CONNECTOR (REAR DOOR COURTESY LIGHT SWITCH RH - THEFT WARNING ECU)
  1. Disconnect the D7 rear door courtesy light switch assembly RH connector.

  1. Disconnect the T36 theft warning ECU assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    D7-1 - T36-7 (CTY)
    Always
    Below 1 Ω
    D7-1 or T36-7 (CTY) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)