THEFT DETERRENT SYSTEM > Rear Door Courtesy Switch RH Circuit |

| 1.INSPECT REAR DOOR COURTESY LIGHT SWITCH ASSEMBLY RH |
![]() |
Remove the rear door courtesy light switch assembly RH (Click here).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 1 - Body ground | Not pushed (ON) | Below 1 Ω |
| Pushed (OFF) | 10 kΩ or higher |
| *a | Not pushed (ON) |
| *b | Pushed (OFF) |
| *c | Body ground |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (REAR DOOR COURTESY LIGHT SWITCH RH - THEFT WARNING ECU) |
Disconnect the D7 rear door courtesy light switch assembly RH connector.
Disconnect the T36 theft warning ECU assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D7-1 - T36-7 (CTY) | Always | Below 1 Ω |
| D7-1 or T36-7 (CTY) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||