Home › ENGINE · 1GR-FE › ENGINE CONTROL SYSTEM › SFI SYSTEM

SFI SYSTEM > VC Output Circuit

for Preparation Click here


DESCRIPTION

The VC voltage (5 V) is generated in the ECM. The voltage is used to supply power to the throttle position sensor, camshaft position sensor and crankshaft position sensor.

WIRING DIAGRAM


A120393E01


INSPECTION PROCEDURE

1.CHECK MIL
  1. Check that the Malfunction Indicator Lamp (MIL) lights up when turning the ignition switch ON.

OK:
MIL lights up



OK
SYSTEM OK
NG


2.CHECK CONNECTION BETWEEN INTELLIGENT TESTER AND ECM
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch ON and intelligent tester ON.

  1. Check the communication between the intelligent tester and ECM.

Result:
Condition
Proceed to
Communication is not possible
A
Communication is possible
B



B
GO TO MIL CIRCUIT
A


3.CHECK ECM
A120392E01
  1. Turn the ignition switch ON.

  1. Measure the voltage of the ECM connector.

Result:
Voltage is not 5 V


NEXT


4.CHECK MIL (THROTTLE POSITION SENSOR)
  1. Disconnect the T1 throttle position sensor connector.

  1. Turn the ignition switch ON.

  1. Check the MIL.

Result:
Condition
Proceed to
MIL does not illuminate
A
MIL illuminates
B



B
REPLACE THROTTLE BODY ASSEMBLY
A


5.CHECK MIL (CAMSHAFT POSITION SENSOR [BANK 1])
  1. Disconnect the C21 camshaft position sensor connector.

  1. Turn the ignition switch ON.

  1. Check the MIL.

Result:
Condition
Proceed to
MIL does not illuminate
A
MIL illuminates
B



B
REPLACE CAMSHAFT POSITION SENSOR (BANK 1)
A


6.CHECK MIL (CAMSHAFT POSITION SENSOR [BANK 2])
  1. Disconnect the C20 camshaft position sensor connector.

  1. Turn the ignition switch ON.

  1. Check the MIL.

Result:
Condition
Proceed to
MIL does not illuminate
A
MIL illuminates
B



B
REPLACE CAMSHAFT POSITION SENSOR (BANK 2)
A


7.CHECK WIRE HARNESS (ECM - BODY GROUND)
A120394E01
  1. Disconnect the T1 throttle position sensor connector.

  1. Disconnect the C20 and C21 camshaft position sensor connectors.

  1. Disconnect the E15 ECM connector.

  1. Measure the resistance of the wire harness side connector.

Standard resistance (check for short):
Tester Connection
Specified Condition
E15-23 (VC) - Body ground
10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE ECM