Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › REAR COOLING UNIT

REAR COOLING UNIT > REMOVAL

for Preparation Click here



1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM
  1. Start up the engine.

  1. Turn the A/C switch ON.

  1. Operate the cooler compressor with an engine speed of approximately 1,000 rpm for 5 to 6 minutes to circulate the refrigerant and collect the compressor oil remaining in each component into the cooler compressor.

  1. Stop the engine.

  1. Using SST, discharge the refrigerant gas.

    SST
    09985-20010   (09985-02130, 09985-02150, 09985-02090, 09985-02110, 09985-02010, 09985-02050, 09985-02060, 09985-02070)



2. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



4. REMOVE ROOF HEADLINING ASSEMBLY
(Click here)


5. REMOVE REAR NO. 5 ROOF AIR DUCT


E171275
  1. Detach the 2 clamps.

  1. Remove the 2 clips and rear No. 5 roof air duct.



6. REMOVE REAR NO. 4 ROOF AIR DUCT


E171274
  1. Remove the 3 clips and rear No. 4 roof air duct.



7. REMOVE REAR NO. 3 ROOF AIR DUCT


E171273
  1. Remove the 3 clips and rear No. 3 roof air duct.



8. REMOVE REAR NO. 2 ROOF AIR DUCT


E171277
  1. Remove the 2 clips and rear No. 2 roof air duct.



9. REMOVE REAR NO. 1 ROOF AIR DUCT


E171276
  1. Remove the 3 clips and rear No. 1 roof air duct.



10. REMOVE REAR NO. 1 SIDE AIR DUCT


E225874
  1. Remove the 2 clips.

  1. Detach the 2 claws and remove the rear No. 1 side air duct.



11. REMOVE REAR BUMPER COVER
(Click here)


12. REMOVE QUARTER VENT DUCT ASSEMBLY RH


    E225550
  1. Detach the 5 claws and remove the quarter vent duct assembly RH.



13. DISCONNECT NO. 1 COOLER COVER


    E225551
  1. Remove the packing.



    E225552
  1. Remove the 2 bolts and disconnect the No. 1 cooler cover.



14. DISCONNECT AIR CONDITIONING TUBE AND ACCESSORY ASSEMBLY


E225553
  1. Remove the 2 bolts.

  1. Disconnect the air conditioning tube and accessory assembly.

    NOTICE:
    1. Do not use a screwdriver or similar tool to disconnect the tube.
    2. Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.

  1. Remove the 2 O-rings from the air conditioning tube and accessory assembly.



15. REMOVE REAR COOLING UNIT ASSEMBLY


E171272E01
  1. Remove the bolt labeled A and body ground.

  1. Detach the 4 clamps.

  1. Disconnect the 4 connectors.

  1. Remove the 3 bolts labeled B and rear cooling unit assembly.
    Text in Illustration 
    *1
    Bolt A
    *2
    Bolt B