DRIVE BELT > ON-VEHICLE INSPECTION |
| 1. CHECK DRIVE BELT TENSION |
![]() |
Visually check the belt for cracks, oiliness or wear. Check that the belt does not touch the bottom of the pulley groove.
If necessary, replace the belt.
Check the vane pump V belt.
![]() |
Check the V belt deflection by pressing on the belt at the points indicated in the illustration with 98 N (10 kgf, 22 lbf) of pressure.
| Item | Specified Condition |
| New belt | 7.5 to 9.5 mm (0.30 to 0.37 in.) |
| Used belt | 9.0 to 13 mm (0.35 to 0.51 in.) |
Using a belt tension gauge, check the drive belt tension.
| Item | Specified Condition |
| New belt | 441 to 539 N (45 to 55 kgf) |
| Used belt | 245 to 343 N (25 to 35 kgf) |
w/ Air Conditioning System:
Check the cooler compressor V belt.
![]() |
Check the V belt deflection by pressing on the belt at the points indicated in the illustration with 98 N (10 kgf, 22 lbf) of pressure.
| Item | Specified Condition |
| New belt | 11 to 15 mm (0.43 to 0.59 in.) |
| Used belt | 15 to 20 mm (0.59 to 0.79 in.) |
Using a belt tension gauge, check the V belt tension.
| Item | Specified Condition |
| New belt | 372 to 608 N (38 to 62 kgf) |
| Used belt | 196 to 392 N (20 to 40 kgf) |
Check the fan and generator V belt.
![]() |
Check the V belt deflection by pressing on the belt at the points indicated in the illustration with 98 N (10 kgf, 22 lbf) of pressure.
| Item | Specified Condition |
| New belt | 7.0 to 10 mm (0.28 to 0.39 in.) |
| Used belt | 10 to 14 mm (0.39 to 0.55 in.) |
Using a belt tension gauge, check the V belt tension.
| Item | Specified Condition |
| New belt | 441 to 539 N (45 to 55 kgf) |
| Used belt | 196 to 343 N (20 to 35 kgf) |