Home › BRAKE › BRAKE CONTROL › ANTI-LOCK BRAKE SYSTEM

DTC    C1248/48    Open Circuit in Rear Differential Lock

for Preparation Click here


DESCRIPTION


DTC No.
DTC Detection Condition
Trouble Area
C1248/48
With vehicle speed at 50 km/h (30 mph) or more, rear differential lock switch changes from OFF to ON for 3 seconds or more
  1. Transfer indicator switch
  2. Skid control ECU
  3. Wire harness

WIRING DIAGRAM


F100584E02


INSPECTION PROCEDURE

1.INSPECT TRANSFER INDICATOR SWITCH (REAR DIFFERENTIAL LOCK)


    F052057E03
  1. Measure the resistance of the switch.

Standard resistance:
Tester Connection
Switch Condition
Specified Condition
1 - 2
Pushed
Below 1 Ω
1 - 2
Not pushed
10 kΩ or higher



NG
REPLACE TRANSFER INDICATOR SWITCH (REAR DIFFERENTIAL LOCK)
OK


2.CHECK WIRE HARNESS (TRANSFER INDICATOR SWITCH - SKID CONTROL ECU AND BODY GROUND)


    C123166E05
  1. Disconnect the S2 ECU connector.

  1. Disconnect the T29 switch connector.

  1. Measure the resistance of the wire harness side connectors.

Standard resistance:
Tester Connection
Tester Connection
T29-2 - S2-22 (EXI2)
Below 1 Ω
T29-2 - Body ground
10 kΩ or higher
T29-1 - Body ground
Below 1 Ω



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE BRAKE ACTUATOR ASSEMBLY