Home › BRAKE › BRAKE › BRAKE MASTER CYLINDER (w/o VSC)

BRAKE MASTER CYLINDER (w/o VSC) > INSPECTION

for Preparation Click here



1. CHECK AND ADJUST BRAKE BOOSTER PUSH ROD

NOTICE:
The brake booster interior must not be a vacuum when adjusting the booster. Stop the engine and depress the brake pedal several times until there is no vacuum in the booster.

HINT:
Adjust the booster push rod when the master cylinder is replaced with a new one. Adjustment is not necessary when the master cylinder is reinstalled and the booster is replaced with a new one.



    G028332E05
  1. Set SST on the master cylinder and lower the rod of SST until it just touches the piston.

    SST
    09737-00013  

    HINT:
    SST 09737-00012 can also be used.

  1. Apply chalk to the flat of the rod of SST. Turn SST upside down and measure the clearance between the brake booster push rod and SST.

    Standard clearance:
    0 mm (0 in.)

    If there is clearance between the SST main body and the shell of the brake booster, the push rod is protruding too far.
    If the chalk does not stick to the tip of the brake booster push rod, the push rod protrusion is insufficient.



    F040006E01
  1. If the clearance is not as specified, adjust the length by holding the rod using SST and turning the tip of the rod using a 7 mm socket driver.

    SST
    09737-00020  

    NOTICE:
    Check the push rod clearance again after adjusting.