WINDOW DEFOGGER WIRE > ON-VEHICLE INSPECTION |
| 1. INSPECT BACK DOOR GLASS (DEFOGGER WIRE) |
![]() |
Turn the ignition switch ON.
Turn the defogger switch ON.
![]() ![]() |
Measure the voltage at the center of each defogger wire as shown in the illustration.
| Voltage | Criteria |
| Approx. 5 V | Wire is not broken |
| Approx. 10 or 0 V | Wire is broken |
Place the voltmeter's positive (+) lead against the defogger wire on the battery side.
Place the voltmeter's negative (-) lead with the foil strip against the wire on the ground side.
Slide the positive (+) lead from the battery side to the ground side.
The point where the voltage drops from approximately 10 V to 0 V is where the defogger wire is broken.