ENGINE UNIT > REPLACEMENT |
| 1. REPLACE CONNECTING ROD SMALL END BUSH |
![]() |
Using SST and a press, press out the bushing.
![]() |
Using a round file, lightly file off any roughness from the small end of the connecting rod.
![]() |
Attach a new bush to SST with the ball of SST inside the oil hole of the bush.
![]() |
Align the oil holes of the bush and connecting rod.
![]() |
Using SST and a press, press in the bush.
![]() |
Using a pin hole grinder, hone the bush to obtain the standard clearance between the bush and piston pin.
Check the piston pin fit at normal room temperature.
![]() |
Coat the piston pin with engine oil, and push it into the connecting rod with your thumb.
| 2. REPLACE TIMING BELT CASE SEAL |
![]() |
Using a screwdriver, pry out the oil seal.
![]() |
Using SST and a hammer, tap in a new oil seal until its surface is flush with the timing belt case edge.
Apply MP grease to the lip of the oil seal.
| 3. REPLACE ENGINE REAR OIL SEAL |
![]() |
Using a screwdriver and hammer, tap out the oil seal.
![]() |
Using SST and a hammer, tap in a new oil seal until its surface is flush with the rear oil seal retainer edge.
Apply MP grease to the lip of the oil seal.