Home › ENGINE ยท 2TR-FE › COOLING › RADIATOR

RADIATOR > DISASSEMBLY

for Preparation Click here



1. REMOVE RADIATOR SIDE PLATE RH


    A120273
  1. Remove the 2 bolts and radiator side plate RH.



2. REMOVE RADIATOR SIDE PLATE LH
  1. Remove the 2 bolts and radiator side plate LH.



3. REMOVE RADIATOR DRAIN COCK PLUG
  1. Remove the radiator drain cock plug.

  1. Remove the O-ring.



4. ASSEMBLE SST


    A113337E11
  1. Install the claw to part A of the overhaul handle as shown in the illustration.

    SST
    09230-01010   (09231-01010, 09231-01030)
    Text in Illustration 
    *1
    Part A
    *2
    Stopper Bolt
    *3
    Dimension B

  1. While squeezing the handle, adjust the stopper bolt so that dimension B is as specified below.

    Dimension B:
    0.2 to 0.3 mm (0.00787 to 0.0118 in.)

    NOTICE:
    If this adjustment is not performed, the claw will be damaged.



5. UNCAULK LOCK PLATE


    A113338E05
  1. Using SST, squeeze the handle until stopped by the stopper bolt to release the caulking.

    SST
    09230-01010   (09231-01010, 09231-01030)
    Text in Illustration 
    *1
    Tank
    *2
    Lock Plate



6. REMOVE RADIATOR TANK UPPER AND RADIATOR TANK LOWER


    A099699
  1. Lightly tap the bracket of the radiator (or the connection area for the radiator hose inlet or outlet) with a plastic-faced hammer and remove the tank.

    NOTICE:
    Do not tap automatic transmission oil cooler pipe.

  1. Remove the O-ring.



7. REMOVE OIL COOLER ASSEMBLY


    A099700E01
  1. Remove the 2 cooler pipes.

  1. Remove the 2 nuts, 2 plate washers and oil cooler assembly.

  1. Remove the 2 O-rings from the oil cooler assembly.