Home › ENGINE · 1GR-FE › ENGINE CONTROL SYSTEM › A/F SENSOR HEATER RELAY

A/F SENSOR HEATER RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE AIR FUEL RATIO SENSOR RELAY (Marking: A/F)
  1. Remove the engine room relay block cover.

  1. Remove the relay from the engine room relay block.



3. INSPECT A/F RELAY


    B060778E19
  1. Measure the resistance of the A/F relay.

    Standard resistance:
    Terminal Connection
    Specified Condition
    3 - 5
    10 kΩ or higher
    3 - 5
    Below 1 Ω
    (when battery voltage is applied to terminals 1 and 2)

    If the result is not as specified, replace the relay.



4. INSTALL A/F RELAY


5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL