Home › ENGINE · 5L-E › FUEL › FUEL INJECTION PUMP

FUEL INJECTION PUMP > INSPECTION

for Preparation Click here



1. INSPECT FUEL TEMPERATURE SENSOR


  1. Measure the resistance of the sensor.


    A108624E06

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1 (E2) - 2 (THF)
    20°C (68°F)
    2.21 to 2.69 kΩ
    1 (E2) - 2 (THF)
    80°C (176°F)
    0.287 to 0.349 kΩ

    NOTICE:
    If checking the sensor in water, be careful not to allow water to contact the terminals. After checking, wipe the water off the sensor.

    If the result is not as specified, replace the sensor.



2. INSPECT INJECTION PUMP DELIVERY VALVE


B001267E01

NOTICE:
Do not touch the sliding surface of the delivery valves.

  1. Pull up the valve and release it. Check that it sinks smoothly to the valve seat. If the operation is not as specified, replace the valve and valve seat as a set.

    HINT:
    Before using a new valve set, wash off the rust prevention compound with diesel fuel. Then rewash with diesel fuel and perform the above test.