POWER WINDOW MASTER SWITCH (w/ Jam Protection Function) > INSPECTION |
| 1. INSPECT POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY |

Remove the power window regulator master switch with its connectors still connected.
Measure the voltage of the power window regulator master switch connector.
| Tester Connection | Condition | Specified Condition |
| 4 (U) - 1 (E) | Ignition switch ON, driver side power window switch OFF → UP (manual operation) | Below 1 V → 10 to 14 V |
| Ignition switch ON, driver side power window fully open → driver side power window switch UP (AUTO operation) → driver side power window fully closed | Below 1 V → 10 to 14 V → Below 1 V | |
| 9 (D) - 1 (E) | Ignition switch ON, driver side power window switch OFF → DOWN (manual operation) | Below 1 V → 10 to 14 V |
| Ignition switch ON, driver side power window fully closed → driver side power window switch DOWN (AUTO operation) → driver side power window fully open | Below 1 V → 10 to 14 V → Below 1 V |
| Tester Connection | Condition | Specified Condition |
| 13 (U) - 1 (E) |
| Below 1 V → 10 to 14 V |
| 15 (D) - 1 (E) |
| Below 1 V → 10 to 14 V |
| Tester Connection | Condition | Specified Condition |
| 12 (U) - 1 (E) |
| Below 1 V → 10 to 14 V |
| 10 (D) - 1 (E) |
| Below 1 V → 10 to 14 V |
| Tester Connection | Condition | Specified Condition |
| 18 (U) - 1 (E) |
| Below 1 V → 10 to 14 V |
| 16 (D) - 1 (E) |
| Below 1 V → 10 to 14 V |
![]() |
Apply battery voltage to the master switch and check that the AUTO light illuminates.
| Measurement Condition | Specified Condition |
| Battery positive (+) → Terminal 6 (B) Battery negative (-) → Terminal 1 (E) | AUTO light illuminates |