Home › ENGINE ยท 1KD-FTV › CHARGING › GENERATOR

GENERATOR > REASSEMBLY

for Preparation Click here



1. INSTALL GENERATOR ROTOR ASSEMBLY

NOTICE:
Do not drop the generator rotor assembly.



    A196960E01
  1. Set the spacer ring, drive end frame, generator rotor assembly and SST1 to SST2 as shown in the illustration.

    SST
    09285-76010  
    09630-00014   (09631-00061)

  1. Using SST1, SST2 and a press, slowly press the generator rotor into the drive end frame and spacer ring.

  1. Temporarily install the generator pulley with clutch to the rotor shaft by hand.



2. INSTALL FITTING RING


    A196961
  1. Align the 3 protrustions of the fitting ring with the 3 cutouts of the generator stator with rectifier and install the fitting ring.



3. INSTALL GENERATOR STATOR SUB-ASSEMBLY WITH RECTIFIER
  1. Align the key of the drive end frame with the keyway of the generator stator.



    A117272
  1. Install the stator with the 4 bolts.

    Torque:
    4.3 N*m{ 44 kgf*cm , 38 in.*lbf }



4. INSTALL GENERATOR REGULATOR ASSEMBLY


    A121957
  1. Push in the regulator by hand as shown in the illustration.



  1. Install the regulator with the 3 screws.


    A121958E01

    Torque:
    2.5 N*m{ 25 kgf*cm , 22 in.*lbf } for screw A
    1.2 N*m{ 12 kgf*cm , 11 in.*lbf } for screw B

    HINT:
    Install screw B to the position shown in the illustration.

  1. Install the protective tower.



5. INSTALL GENERATOR REAR END COVER


    A117270E01
  1. Install the rear end cover with the 2 nuts and screw.

    Torque:
    19 N*m{ 194 kgf*cm , 14 ft.*lbf } for nut A
    12 N*m{ 122 kgf*cm , 9 ft.*lbf } for nut B
    2.8 N*m{ 29 kgf*cm , 25 in.*lbf } for screw

    NOTICE:
    The protective tower must be attached to the end cover.



    A117269
  1. Install the 2 terminal covers by turning them clockwise.



6. TIGHTEN GENERATOR PULLEY WITH CLUTCH
  1. Mount the generator assembly in a vise between aluminum plates.



    A200681E01
  1. Set SST and an 8 mm bi-hexagon wrench to the pulley as shown in the illustration.

    SST
    09820-30010  



    A200683E01
  1. Hold SST in place, rotate the 8 mm bi-hexagon wrench counterclockwise to tighten the generator pulley with clutch.

    Torque:
    80 N*m{ 816 kgf*cm , 59 ft.*lbf }



7. INSTALL GENERATOR PULLEY CAP


    A196964E01
  1. Install a new generator pulley cap.

    NOTICE:
    1. Align the cap guide of the generator pulley cap with the hole of the generator pulley and push it in by hand.
    2. Do not push in the generator pulley cap at an angle.