DTC 15 (4) Throttle Motor Circuit Malfunction |
| DTC No. | DTC Detection Condition | Trouble Area |
| 15 (4) | Open or short in throttle control motor circuit |
|
| Open or short in throttle open switch circuit |

| 1.INSPECT THROTTLE OPEN SWITCH |
![]() |
Disconnect the T32 throttle open switch connector.
Remove the venturi.
Measure the resistance of the throttle open switch.
| Tester Connection | Throttle Valve Condition | Specified Condition |
| 1 - 2 | Open | Below 1 Ω |
| 1 - 2 | Closed | 10 kΩ or higher |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (THROTTLE OPEN SWITCH - ECM AND BODY GROUND) |
![]() |
Disconnect the T32 throttle open switch connector.
Disconnect the E21 ECM connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| T32-1 - Body ground | Below 1 Ω |
| E21-15 (THOP) - T32-2 | Below 1 Ω |
| E21-15 (THOP) or T32-2 - Body ground | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.CHECK ECM (THROTTLE CONTROL MOTOR CIRCUIT) |
![]() |
During engine racing, measure the waveform according to the value(s) in the table below.
| Tester Connection | Specified Condition |
| E20-10 (LU+A) - E20-13 (E01) | Correct waveform is as shown |
| E20-9 (LU-A) - E20-13 (E01) | Correct waveform is as shown |
| E20-8 (LU+B) - E20-13 (E01) | Correct waveform is as shown |
| E20-7 (LU-B) - E20-13 (E01) | Correct waveform is as shown |
| Tool Setting | Condition |
| 10 V/DIV., 0.5 msec./DIV. | During engine racing |
|
| ||||
| NG | |
| 4.INSPECT THROTTLE CONTROL MOTOR |
![]() |
Disconnect the T31 throttle control motor connector.
Measure the resistance of the throttle control motor.
| Tester Connection | Condition | Specified Condition |
| 1 - 2 | 20°C (68°F) | 18 to 22 Ω |
| 2 - 3 | 20°C (68°F) | 18 to 22 Ω |
| 4 - 5 | 20°C (68°F) | 18 to 22 Ω |
| 5 - 6 | 20°C (68°F) | 18 to 22 Ω |
|
| ||||
| OK | |
| 5.CHECK HARNESS AND CONNECTOR (THROTTLE CONTROL MOTOR - ECM) |
![]() |
Disconnect the T31 throttle control motor connector.
Disconnect the E20 ECM connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| T31-6 - E20-10 (LU+A) | Below 1 Ω |
| T31-4 - E20-9 (LU-A) | Below 1 Ω |
| T31-3 - E20-8 (LU+B) | Below 1 Ω |
| T31-1 - E20-7 (LU-B) | Below 1 Ω |
| E20-10 (LU+A) - E20-13 (E01) | 10 kΩ or higher |
| E20-9 (LU-A) - E20-13 (E01) | 10 kΩ or higher |
| E20-8 (LU+B) - E20-13 (E01) | 10 kΩ or higher |
| E20-7 (LU-B) - E20-13 (E01) | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||