Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › COMPRESSOR (for 5L-E)

COMPRESSOR (for 5L-E) > REMOVAL

for Preparation Click here



1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM
  1. Start up the engine.

  1. Turn the A/C switch ON.

  1. Operate the cooler compressor with an engine speed of approximately 1,000 rpm for 5 to 6 minutes to circulate the refrigerant and collect the compressor oil remaining in each component into the cooler compressor.

  1. Stop the engine.

  1. Using SST, discharge the refrigerant gas.

    SST
    09985-20010   (09985-02130, 09985-02150, 09985-02090, 09985-02110, 09985-02010, 09985-02050, 09985-02060, 09985-02070)



2. REMOVE AIR CLEANER ASSEMBLY
  1. Disconnect the IAT sensor connector.

  1. Loosen the air cleaner hose clamp.

  1. Remove the 2 bolts and air cleaner.



3. REMOVE DRIVE BELT
(Click here)


4. DISCONNECT SUCTION HOSE SUB-ASSEMBLY


    E235995
  1. Remove the bolt and disconnect the suction hose sub-assembly from the compressor.

  1. Remove the O-ring from the suction hose sub-assembly.

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering.



5. DISCONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE


    E235996
  1. Remove the bolt and disconnect the No. 1 cooler refrigerant discharge hose from the compressor.

  1. Remove the O-ring from the No. 1 cooler refrigerant discharge hose.

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering.



6. REMOVE COOLER COMPRESSOR ASSEMBLY


    E235997
  1. Disconnect the connector.



    E235998
  1. Remove the 4 bolts and cooler compressor assembly.