DTC U0101 Lost Communication with TCM |
| DTC No. | DTC Detection Condition | Trouble Area |
| U0101 |
|
|

| 1.CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC U0101) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON.
Turn the tester ON.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Read the DTCs.
| Display (DTC output) | Proceed to |
| U0101 | A |
| U0101 and other DTCs | B |
|
| ||||
| A | |
| 2.INSPECT TCM |
![]() |
Disconnect the T37 TCM connector.
Turn the ignition switch ON.
Measure the voltage of the wire harness side connector.
| Tester Connection | Specified Condition |
| T37-5 (BATT) - Body ground | 11 to 14 V |
![]() |
Disconnect the T19 TCM connector.
Measure the resistance of the wire harness side connector.
| Tester Connection | Specified Condition |
| T19-1 (E1) - Body ground | Below 1 Ω |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (ECM - TCM) |
![]() |
Disconnect the E5 ECM connector.
Disconnect the T37 TCM connector.
Measure the resistance of the wire harness side connector.
| Tester Connection | Specified Condition |
| E5-22 (CAN+) - T37-21 (CAN+) | Below 1 Ω |
| E5-21 (CAN-) - T37-20 (CAN-) | Below 1 Ω |
| Tester Connection | Specified Condition |
| E5-22 (CAN+) or T37-21 (CAN+) - Body ground | 10 kΩ or higher |
| E5-21 (CAN-) or T37-20 (CAN-) - Body ground | 10 kΩ or higher |
|
| ||||
| OK | |
| 4.REPLACE ECM |
Replace the ECM (Click here).
| NEXT | |
| 5.CHECK WHETHER DTC OUTPUT RECURS (DTC U0101) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON and turn the tester ON.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Read the DTCs.
| Display (DTC output) | Proceed to |
| No output | A |
| U0101 | B |
|
| ||||
| A | ||
| ||