Home › BODY › WINDSHIELD / WINDOWGLASS › WINDOW DEFOGGER SWITCH

WINDOW DEFOGGER SWITCH > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT REAR WINDOW DEFOGGER SWITCH ASSEMBLY


B085675E02
  1. Check the illumination area of the switch.

    Standard measurement:
    Measurement Condition
    Specified Condition
    Battery positive (+) → 1 (ILL+)
    Battery negative (-) → 1 (ILL+)
    Illuminates

    If the result is not as specified, replace the switch assembly.

    HINT:
    The ON/OFF indicator of the switch will not illuminate.



    B085676E02
  1. Check the ON/OFF indicator of the switch.

    1. Push the switch several times. Check that the ON/OFF indicator illuminates or turns off according to switch operation.

      Standard measurement:
      Measurement Condition
      Switch Condition
      Specified Condition
      Battery positive (+) → 5 (IG)
      Battery negative (-) → 3 (E)
      Defogger switch ON
      Illuminates

      If the result is not as specified, replace the switch assembly.

      HINT:
      The illumination area of the switch will not illuminate.



    B085677E01
  1. Measure the resistance of the switch.

    Standard resistance:
    Measurement Condition
    Switch Condition
    Specified Condition
    4 (D) - 3 (E)
    ON
    Below 1 Ω
    4 (D) - 3 (E)
    OFF
    10 kΩ or higher

    If the result is not as specified, replace the switch assembly.