LIGHTING SYSTEM > Warning Light Circuit |

| 1.INSPECT COMBINATION METER ASSEMBLY |
Remove the combination meter assembly (Click here).

Connect the positive (+) lead from the battery to terminal A-21 and the negative (-) lead to terminal B-22.
Check that the warning light comes on.
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - BATTERY) |
![]() |
Disconnect the C27 combination meter connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| C27-21 - Body ground | Ignition switch ON | 11 to 14 V |
| Ignition switch off | Below 1 V |
| *a | Front view of wire harness connector (to Combination Meter Assembly) |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - HEADLIGHT LEVELING ECU ASSEMBLY) |
Disconnect the C28 combination meter connector.
Disconnect the H17 headlight leveling ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| H17-6 (WNG) - C28-22 | Always | Below 1 Ω |
| H17-6 (WNG) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||