Home › TRANSMISSION ยท CLUTCH › CLUTCH UNIT (for KD Series Engine)

CLUTCH UNIT (for KD Series Engine) > INSPECTION

for Preparation Click here



1. INSPECT CLUTCH DISC ASSEMBLY


C062956E06
  1. Using a vernier caliper, measure the rivet head depth.

    Minimum rivet depth:
    0.3 mm (0.012 in.)

    If the depth is less than the minimum, replace the clutch disc assembly.



    CL00373E03
  1. Install the clutch disc to the transmission unit.

    NOTICE:
    Be careful not to insert the clutch disc facing the wrong direction.

  1. Using a dial indicator, check the disc runout.

    Maximum runout:
    0.8 mm (0.031 in.)

    If the runout is greater than the maximum, replace the clutch disc assembly.



2. INSPECT CLUTCH COVER ASSEMBLY


D025281E05
  1. Using a vernier caliper, measure the depth and width of the worn areas of the diaphragm spring.

    Maximum wear:
    Measurement
    Maximum wear
    A (Depth)
    0.5 mm (0.020 in.)
    B (Width)
    6.0 mm (0.236 in.)

    If the depth or width is greater than the maximum, replace the clutch cover assembly.



3. INSPECT FLYWHEEL SUB-ASSEMBLY


Q007250E03
  1. Using a dial indicator, measure the flywheel runout.

    Maximum runout:
    0.1 mm (0.004 in.)

    If the runout is greater than the maximum, replace the flywheel sub-assembly.



4. INSPECT CLUTCH RELEASE BEARING ASSEMBLY


N000414E04
  1. Turn the bearing by hand while applying force in the axial direction.
    If the bearing sticks or has much resistance, replace the release bearing.

    HINT:
    The bearing is permanently lubricated and requires no cleaning or lubrication.