1GR-FE STARTING > SERVICE DATA |
| Starter | Rated voltage and output power | 12 V 1.6 kW | |
| No-load characteristics current | 90 A or less at 11.5 V | ||
| Starter relay | Tester connection 3 - 5 | Specified resistance | 10 MΩ or higher |
| Below 1 Ω (when battery voltage is applied to terminals 1 and 2) | |||
| Ignition switch | Tester connection - | Switch condition LOCK | Specified condition 10 kΩ or higher |
| Tester connection 2 (ACC) - 4 (AM1) | Switch condition ACC | Specified condition Below 1 Ω | |
| Tester connection 1 (IG1) - 4 (AM1) 2 (ACC) - 4 (AM1) 5 (AM2) - 6 (IG2) | Switch condition ON | Specified condition Below 1 Ω | |
| Tester connection 1 (IG1) - 4 (AM1) 3 (ST1) - 4 (AM1) 5 (AM2) - 6 (IG2) 5 (AM2) - 7 (ST2) | Switch condition START | Specified condition Below 1 Ω | |
| Starter armature assembly | Standard depth | 3.1 mm (0.122 in.) | |
| Maximum depth | 3.8 mm (0.150 in.) | ||
| Specified resistance | Segment - Segment | Below 1 Ω | |
| Segment - Coil core | 10 kΩ or higher | ||
| Commutator end frame assembly | Brush | Standard length | 9.0 mm (0.354 in.) |
| Minimum length | 4.0 mm (0.158 in.) | ||
| Specified resistance | Positive (+) - Negative (-) brush | 10 kΩ or higher | |
| Snap ring | Maximum length | 5.0 mm (0.197 in.) | |