REAR BLOWER CONTROL SWITCH > INSTALLATION |
| 1. INSTALL COOLER (REAR) SWITCH |
Connect the connector.
Attach the 2 claws to install the cooler (rear) switch.
| 2. INSTALL SWITCH BASE |
Connect the connectors.
Attach the 9 claws and guide to install the switch base.
| 3. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY |
Attach the 3 guides, 2 claws and 3 clips to install the lower instrument panel finish panel.
| 4. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY |
![]() |
Attach the 2 hinges to install the glove compartment door.
| *1 | Hinge |
![]() |
While pushing in the sides of the glove compartment door as indicated by the arrows in the illustration, close the door to engage it to the 2 stoppers.
| *1 | Stopper |
| 5. INSTALL COOLER CONTROL SWITCH ASSEMBLY |
Connect the connector.
![]() |
Attach the 2 clips to install the cooler control switch assembly (rear blower switch) as shown in the illustration.