Item
| Outline
|
Detection of abnormal input voltage (High input voltage)
| If voltage that is input to the headlight light control ECU is approximately 20 V or more, the ECU stops illuminating the headlights, and resumes when the voltage drops to 16 V or less.
|
Detection of abnormal input voltage (Low input voltage)
| If voltage that is input to the headlight light control ECU is 6 V or less, the ECU stops illuminating the low beam headlights, and resumes when the voltage is 10 V or more.
|
Detection of abnormal output
- Output open
- Short between output terminals
- Short between output terminal and body ground
| If an abnormal condition occurs in the voltage that is output by the headlight light control ECU, the ECU stops illuminating the low beam headlights and will maintain this state until power is reinstated (by turning the headlight dimmer switch from off to head).
|
Detection of abnormal light voltage (Low light voltage)
| Approximately 80 seconds after input voltage is supplied, if the light voltage is below approximately 31 V for approximately 0.5 seconds, the headlight light control ECU stops illuminating the low beam headlights and will maintain this state until power is reinstated (by turning the headlight dimmer switch from off to head).
|
Detection of abnormal light voltage (High light voltage)
| If the light voltage is above approximately 69 V for approximately 0.5 seconds, the headlight light control ECU stops illuminating the low beam headlights and will maintain this state until power is reinstated (by turning the headlight dimmer switch from off to head).
|