Terminal No. (Symbol)
| Wiring Color
| Terminal Description
| Condition
| Specified Condition
|
A38-2 (BLW) - Body ground
| L-B - Body ground
| Blower motor speed control voltage
| - Ignition switch ON
- Blower switch on (LO level)
| Pulse generation (See waveform 1)
|
A38-3 (AOF) - A38-1 (GND)
| Y-B - L
| Mode damper servo operation voltage
| - Ignition switch ON
- Blower switch on (LO level)
- Mode switch DEF
| Below 1 V
|
- Ignition switch ON
- Blower switch on (LO level)
- Mode switch FACE
| 11 to 14 V
|
A38-4 (AOD) - A38-1 (GND)
| R-B - L
| Mode damper servo operation voltage
| - Ignition switch ON
- Blower switch on (LO level)
- Mode switch FACE
| Below 1 V
|
- Ignition switch ON
- Blower switch on (LO level)
- Mode switch DEF
| 11 to 14 V
|
A38-7 (ACT) - A38-1 (GND)
| R-L - L
| Magnet clutch on permit input signal
| - Engine idling
- Blower switch on (LO level)
- A/C switch off or on (magnet clutch off)
| Below 1 V
|
- Engine idling
- Blower switch on (LO level)
- A/C switch on (magnet clutch on)
| 11 to 14 V
|
A38-8 (TW) - A38-1 (GND)
| P - L
| Engine coolant temperature sensor signal
| Ignition switch ON
| Pulse generation
|
A38-9 (SPD) - Body ground
| V-W - Body ground
| Vehicle speed signal
| Driving at approximately 20 km/h (12 mph)
| Pulse generation (See waveform 2)
|
A38-13 (MGC) - Body ground
| B - Body ground
| Magnet clutch signal
| - Engine idling
- A/C switch on (magnet clutch on permitted)
| Below 1 V
|
- Engine idling
- A/C switch off or on (magnet clutch on not permitted)
| 11 to 14 V
|
A38-17 (AMH) - A38-1 (GND)
| L - L
| Air mix damper servo operation signal
| - Ignition switch ON
- Blower switch on (LO level)
- Temperature switch MAX HOT
| 11 to 14 V
|
- Ignition switch ON
- Blower switch on (LO level)
- Temperature switch MAX COLD
| Below 1 V
|
A38-18 (TAMO) - A38-1 (GND)
| P - L
| Ambient temperature signal
| Ignition switch ON
| Pulse generation
|
A38-19 (AMC) - A38-1 (GND)
| R-W - L
| Air mix damper servo operation signal
| - Ignition switch ON
- Blower switch on (LO level)
- Temperature switch MAX HOT
| Below 1 V
|
- Ignition switch ON
- Blower switch on (LO level)
- Temperature switch MAX COLD
| 11 to 14 V
|
A38-21 (AC1) - A38-1 (GND)
| Y - L
| Idle-up request signal
| - Engine idling
- Blower switch on (LO level)
- A/C switch off
| 11 to 14 V
|
- Engine idling
- Blower switch on (LO level)
- A/C switch on
| Below 1 V
|
A38-22 (AIR) - A38-1 (GND)
| L-W - L
| Recirculation damper servo operation voltage
| - Ignition switch ON
- Blower switch on (LO level)
- Fresh switch on
| Below 1 V
|
- Ignition switch ON
- Blower switch on (LO level)
- Recirculation switch on
| 11 to 14 V
|
A38-23 (AIF) - A38-1 (GND)
| G-Y - L
| Recirculation damper servo operation voltage
| - Ignition switch ON
- Blower switch on (LO level)
- Recirculation switch on
| Below 1 V
|
- Ignition switch ON
- Blower switch on (LO level)
- Fresh switch on
| 11 to 14 V
|
A37-1 (TE) - A37-14 (SG-4)
| G - P
| No. 1 cooler thermistor signal
| - Ignition switch ON
- Evaporator temperature 0°C (32°F)
| 2.0 to 2.4 V
|
- Ignition switch ON
- Evaporator temperature 15°C (59°F)
| 1.4 to 1.8 V
|
A37-2 (S5-3) - A38-1 (GND)
| W-R - L
| Power supply for solar sensor
| Ignition switch ON
| 4.5 to 5.5 V
|
A37-5 (PSW) - A38-1 (GND)
| Y-B - L
| Air conditioner pressure sensor signal
| - Engine idling
- Refrigerant pressure normal
| Below 1 V
|
- Engine idling
- Refrigerant pressure less than 0.196 MPa (2.0 kgf/cm2, 28 psi) or more than 3.14 MPa (32.0 kgf/cm2, 455 psi)
| 11 to 14 V
|
A37-7 (TS) - A37-2 (S5-3)
| L-W - W-R
| Solar sensor signal
| - Ignition switch ON
- Solar sensor subjected to electric light
- Vehicle indoors
| 0.8 to 4.3 V
|
- Ignition switch ON
- Solar sensor covered with cloth
- Vehicle indoors
| Below 0.8 V
|
A37-11 (SG-2) - Body ground
| L-Y - Body ground
| Ground for pulse position sensor (Mode damper servo)
| Always
| Below 1 Ω
|
A37-13 (SG-3) - Body ground
| BR-Y - Body ground
| Ground for cooler thermistor
| Always
| Below 1 Ω
|
A37-14 (SG-4) - Body ground
| P - Body ground
| Ground for No. 1 cooler thermistor
| Always
| Below 1 Ω
|
A37-16 (AGND) - A37-21 (AUXO)
| R-L - LG-R
| Input signal for pulse position sensor (recirculation damper servo)
| - Ignition switch ON
- Blower switch on (LO level)
- Air inlet control recirculation to fresh or vice versa
| Pulse generation
|
A37-17 (PIA) - A37-21 (AUXO)
| P-B - LG-R
| Input signal for pulse position sensor (recirculation damper servo)
| - Ignition switch ON
- Blower switch on (LO level)
- Air inlet control recirculation to fresh or vice versa
| Pulse generation
|
A37-18 (TR) - A37-13 (SG-3)
| GR - BR-Y
| Cooler thermistor signal
| - Ignition switch ON
- Cabin temperature 25°C (77°F)
| 1.8 to 2.2 V
|
- Ignition switch ON
- Cabin temperature 40°C (104°F)
| 1.2 to 1.6 V
|
A37-20 (SG-1) - Body ground
| BR-Y - Body ground
| Ground for pulse position sensor (air mix damper servo)
| Always
| Below 1 V
|
A37-21 (AUXO) - Body ground
| LG-R - Body ground
| Ground for pulse position sensor (recirculation damper servo)
| Always
| Below 1 Ω
|
A37-23 (PMB) - A37-20 (SG-1)
| W-L - BR-Y
| Input signal for pulse position sensor (air mix damper servo)
| - Ignition switch ON
- Blower switch on (LO level)
- Temperature switch MAX HOT to MAX COLD
| Pulse generation
|
A37-24 (PMA) - A37-20 (SG-1)
| W-R - BR-Y
| Input signal for pulse position sensor (air mix damper servo)
| - Ignition switch ON
- Blower switch on (LO level)
- Temperature switch MAX COLD to MAX HOT
| Pulse generation
|
A37-25 (POB) - A37-11(SG-2 )
| LG - L-Y
| Input signal for pulse position sensor (mode damper servo)
| - Ignition switch ON
- Blower switch on (LO level)
- Mode control FACE to DEF or vice versa
| Pulse generation
|
A37-26 (POA) - A37-11 (SG-2)
| L-O - L-Y
| Input signal for pulse position sensor (mode damper servo)
| - Ignition switch ON
- Blower switch on (LO level)
- Mode control FACE to DEF or vice versa
| Pulse generation
|