Home › BODY ELECTRICAL › AUDIO / VISUAL › AUDIO AND VISUAL SYSTEM (for Radio Receiver Type)

AUDIO AND VISUAL SYSTEM (for Radio Receiver Type) > Microphone Circuit between Microphone and Radio Receiver

for Preparation Click here


DESCRIPTION

Using this circuit, the radio receiver assembly sends power to the telephone microphone assembly, and the telephone microphone assembly sends microphone signals to the radio receiver assembly.

WIRING DIAGRAM


E277658E13


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - MAP LIGHT ASSEMBLY)
  1. Disconnect the R27 radio receiver assembly connector.

  1. Disconnect the M4 map light assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    R27-6 (SNS2) - Body ground
    Always
    Below 1 Ω
    R27-4 (MACC) - M4-4 (MACC)
    Always
    Below 1 Ω
    R27-5 (MIN+) - M4-3 (MCO+)
    Always
    Below 1 Ω
    R27-19 (MIN-) - M4-2 (MCO-)
    Always
    Below 1 Ω
    R27-4 (MACC) - Body ground
    Always
    10 kΩ or higher
    R27-5 (MIN+) - Body ground
    Always
    10 kΩ or higher
    R27-19 (MIN-) - Body ground
    Always
    10 kΩ or higher
    R27-18 (SGND) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.CHECK RADIO RECEIVER ASSEMBLY


    E280108E25
  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    R27-4 (MACC) - Body ground
    Ignition switch ACC
    4 to 6 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    R27-18 (SGND) - Body ground
    Always
    Below 1 Ω
    R27-19 (MIN-) - Body ground
    Always
    Below 1 Ω

Text in Illustration 
*a
Component with harness connected
(Radio Receiver Assembly)


NG
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
OK


3.CHECK TELEPHONE MICROPHONE ASSEMBLY
  1. Replace the telephone microphone assembly with a known good one (Click here).

  1. Check that the malfunction disappears.

    OK:
    Malfunction disappears.



NG
REPLACE MAP LIGHT ASSEMBLY (Click here)
OK

END (TELEPHONE MICROPHONE ASSEMBLY IS DEFECTIVE)