DTC P0047 Turbocharger/Supercharger Boost Control "A" Circuit Low |
DTC P0048 Turbocharger/Supercharger Boost Control "A" Circuit High |
| DTC Detection Drive Pattern | DTC Detection Condition | Trouble Area |
| Drive the vehicle with a city driving pattern at least 10 minutes. | Both of following conditions met for 1 second or more (1 trip detection logic):
|
|
| DTC Detection Drive Pattern | DTC Detection Condition | Trouble Area |
| Drive the vehicle with a city driving pattern at least 10 minutes. | DC motor current 6.5 A or more for 0.5 seconds or more (1 trip detection logic) |
|
| 1.CHECK TURBOCHARGER SUB-ASSEMBLY (DC MOTOR OPERATION) |
Turn the ignition switch to ON.
Turn the ignition switch off and check the DC motor operation (check the operation link movement).

|
| ||||
| OK | ||
| ||
| 2.INSPECT TURBOCHARGER SUB-ASSEMBLY (DC MOTOR) |
![]() |
Disconnect the DC motor connector.
Measure the DC motor resistance.
| *a | Component without harness connected (DC Motor) |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (DC MOTOR - TURBO MOTOR DRIVER) |
Disconnect the DC motor connector.
Disconnect the turbo motor driver connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| T34-12 (M+) - T10-2 (M+) | Always | Below 1 Ω |
| T34-5 (M-) - T10-1 (M-) | Always | Below 1 Ω |
| T34-12 (M+) or T10-2 (M+) - Body ground | Always | 10 kΩ or higher |
| T34-5 (M-) or T10-1 (M-) - Body ground | Always | 10 kΩ or higher |
Reconnect the turbo motor driver connector.
Reconnect the DC motor connector.
|
| ||||
| OK | |
| 4.REPLACE TURBO MOTOR DRIVER |
Replace the turbo motor driver .
| NEXT | |
| 5.CHECK WHETHER DTC OUTPUT RECURS (DTC P0047 AND/OR P0048) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON and turn the intelligent tester on.
Clear the DTCs (Click here).
Drive the vehicle with a city driving pattern at least 10 minutes.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Read the DTCs.
| Result | Proceed to |
| P0047 and/or P0048 is output | A |
| No DTC is output | B |
|
| ||||
| A | |
| 6.REPLACE TURBOCHARGER SUB-ASSEMBLY |
Replace turbocharger sub-assembly (Click here).
|
| ||||
| 7.REPAIR OR REPLACE HARNESS OR CONNECTOR |
Repair or replace the harness or connector.
| NEXT | |
| 8.CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON and turn the tester on.
Clear the DTCs (Click here).
Turn the ignition switch off.
Remove the EFI fuse from the engine room relay block and junction block assembly for more than 1 minute.
Turn the ignition switch to ON and wait for 10 seconds or more.
Start the engine.
Drive the vehicle with a city driving pattern at least 10 minutes.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Confirm that the DTC is not output again.
| NEXT | ||
| ||