DTC P1264 VN Turbo Controller Malfunction |

| DTC No. | DTC Detection Condition | Trouble Area |
| P1264 | When communication error occurs between turbo motor and ECM (1 trip detection logic) |
|

| 1.INSPECT TURBO MOTOR DRIVER |
![]() |
Disconnect the T34 turbo motor driver connector.
Turn the ignition switch ON.
Measure the voltage of the turbo motor driver connector.
| Tester Connection | Specified Condition |
| T34-3 (+B) - T34-4 (GND) | 11 to 14 V |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (TURBO MOTOR DRIVER - ECM) |
![]() |
Disconnect the E7 ECM connector.
Disconnect the T34 turbo motor driver connector.
Measure the resistance of the wire harness side connector.
| Tester Connection | Specified Condition |
| E7-10 (VNTO) - T34-7 (VNTO) | Below 1 Ω |
| E7-17 (VNTI) - T34-2 (VNTI) | Below 1 Ω |
| Tester Connection | Specified Condition |
| E7-10 (VNTO) or T34-7 (VNTO) - Body ground | 10 kΩ or higher |
| E7-17 (VNTI) or T34-2 (VNTI) - Body ground | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.INSPECT ECM (VNTO VOLTAGE) |
![]() |
While idling the engine, check the waveform of the ECM connectors using an oscilloscope.
| Tester Connection | Specified Condition |
| E7-10 (VNTO) - E6-7 (E1) | Correct waveform is as shown |
|
| ||||
| OK | |
| 4.INSPECT TURBO MOTOR DRIVER (VNTI VOLTAGE) |
![]() |
While idling the engine, check the waveform of the ECM connectors using an oscilloscope.
| Tester Connection | Specified Condition |
| E7-17 (VNTI) - E6-7 (E1) | Correct waveform is as shown |
|
| ||||
| OK | ||
| ||