EGR VALVE > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE DIESEL THROTTLE BODY ASSEMBLY |
| 3. REMOVE NO. 1, NO. 2 AND NO. 3 INJECTION PIPE SUB-ASSEMBLY |
![]() |
Remove the 2 nuts and No. 3 injection pipe clamp.
![]() |
Remove the 2 bolts and 2 No. 2 injection pipe clamps.
![]() |
Using a 17 mm union nut wrench, loosen the union nuts and remove the No. 1, No. 2 and No. 3 injection pipes.
| *a | Injector Side |
| *b | Common Rail Side |
| 4. REMOVE NO. 2 INTAKE AIR CONNECTOR BRACKET |
![]() |
Remove the 3 bolts and No. 2 intake air connector bracket.
| 5. DISCONNECT NO. 3 WATER BY-PASS PIPE |
![]() |
Remove the 2 bolts and disconnect the No. 3 water by-pass pipe with the wire harness.
| 6. REMOVE ELECTRIC VACUUM REGULATING VALVE ASSEMBLY (for EGR) |
![]() |
Disconnect the 2 connectors.
![]() |
Disconnect the 6 vacuum hoses.
Remove the bolt and No. 1 gas filter with gas filter bracket.
![]() |
Remove the 2 bolts and electric vacuum regulating valve.
| 7. REMOVE NO. 2 INTAKE AIR CONNECTOR |
![]() |
Remove the 3 nuts, No. 2 intake air connector and gasket.
| 8. REMOVE INTAKE AIR CONNECTOR |
![]() |
Remove the 3 bolts, intake air connector and 2 gaskets.
| 9. REMOVE ELECTRIC EGR CONTROL VALVE ASSEMBLY WITH NO. 1 EGR PIPE SUB-ASSEMBLY |
![]() |
Remove the 2 nuts, electric EGR control valve with No. 1 EGR pipe and gasket.
| 10. REMOVE NO. 1 EGR PIPE SUB-ASSEMBLY |
![]() |
Remove the 2 bolts, No. 1 EGR pipe and gasket from the EGR valve adapter.
| 11. REMOVE EGR VALVE ADAPTER |
![]() |
Remove the 2 bolts, EGR valve adapter and gasket from the electric EGR control valve.