Home › ENGINE ยท 2KD-FTV › EMISSION CONTROL › EGR VALVE

EGR VALVE > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



2. REMOVE DIESEL THROTTLE BODY ASSEMBLY
(Click here)


3. REMOVE NO. 1, NO. 2 AND NO. 3 INJECTION PIPE SUB-ASSEMBLY

NOTICE:
  1. After removing the fuel pipe, cover the outlets on the common rail with tape to keep out foreign matter.
  2. After removing the fuel pipe, put it in a plastic bag to prevent foreign matter from contaminating its injector inlet.



    A211871
  1. Remove the 2 nuts and No. 3 injection pipe clamp.



    A211872
  1. Remove the 2 bolts and 2 No. 2 injection pipe clamps.



    A211873E02
  1. Using a 17 mm union nut wrench, loosen the union nuts and remove the No. 1, No. 2 and No. 3 injection pipes.
    Text in Illustration 
    *a
    Injector Side
    *b
    Common Rail Side



4. REMOVE NO. 2 INTAKE AIR CONNECTOR BRACKET


    A147215
  1. Remove the 3 bolts and No. 2 intake air connector bracket.



5. DISCONNECT NO. 3 WATER BY-PASS PIPE


    A147216
  1. Remove the 2 bolts and disconnect the No. 3 water by-pass pipe with the wire harness.



6. REMOVE ELECTRIC VACUUM REGULATING VALVE ASSEMBLY (for EGR)


    A211846
  1. Disconnect the 2 connectors.



    A252294
  1. Disconnect the 6 vacuum hoses.

  1. Remove the bolt and No. 1 gas filter with gas filter bracket.



    A211848
  1. Remove the 2 bolts and electric vacuum regulating valve.



7. REMOVE NO. 2 INTAKE AIR CONNECTOR


    A147230
  1. Remove the 3 nuts, No. 2 intake air connector and gasket.



8. REMOVE INTAKE AIR CONNECTOR


    A147219
  1. Remove the 3 bolts, intake air connector and 2 gaskets.



9. REMOVE ELECTRIC EGR CONTROL VALVE ASSEMBLY WITH NO. 1 EGR PIPE SUB-ASSEMBLY


    A211879
  1. Remove the 2 nuts, electric EGR control valve with No. 1 EGR pipe and gasket.



10. REMOVE NO. 1 EGR PIPE SUB-ASSEMBLY


    A211849
  1. Remove the 2 bolts, No. 1 EGR pipe and gasket from the EGR valve adapter.



11. REMOVE EGR VALVE ADAPTER


    A211850
  1. Remove the 2 bolts, EGR valve adapter and gasket from the electric EGR control valve.