ECD SYSTEM > Injector Circuit |
| 1.CHECK INJECTOR DRIVER (POWER SOURCE) |
![]() |
Disconnect the injector driver connectors.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| I14-2 (+B) - I14-3 (GND) | Ignition switch ON | 11 to 14 V |
| *a | Front view of wire harness connector (to Injector Driver) |
Reconnect the injector driver connector.
|
| ||||
| OK | ||
| ||
| 2.INSPECT NO. 1 INTEGRATION RELAY (EDU) |
Inspect the No. 1 integration relay (EDU) (Click here).
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (NO. 1 INTEGRATION RELAY [EDU] - INJECTOR DRIVER) |
Remove the No. 1 integration relay from the engine room relay block and junction block assembly.
Disconnect the injector driver connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I14-2 (+B) - 1J-8 | Always | Below 1 Ω |
| I14-3 (GND) - Body ground | Always | Below 1 Ω |
| I14-2 (+B) or 1J-8 - Body ground | Always | 10 kΩ or higher |
Reconnect the No. 1 injector driver connector.
Reinstall the integration relay.
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (NO. 1 INTEGRATION RELAY - ECM) |
Remove the No. 1 integration relay from the engine room relay block and junction block assembly.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E4-10 (IREL) - 1J-7 | Always | Below 1 Ω |
| E4-10 (IREL) or 1J-7 - Body ground | Always | 10 kΩ or higher |
Reconnect the ECM connector.
Reinstall the No. 1 integration relay.
|
| ||||
| OK | ||
| ||