Home › SECURITIES › ENGINE IMMOBILISER › TRANSPONDER KEY AMPLIFIER

TRANSPONDER KEY AMPLIFIER > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for RHD and LHD vehicles.
  2. The procedure listed below is for LHD vehicles.



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, systems need to be initialized after the cable is reconnected (Click here).



2. REMOVE STEERING COLUMN LOWER COVER


    C238860
  1. Remove the 3 screws and lower cover.



3. REMOVE STEERING COLUMN UPPER COVER
  1. Detach the claw and remove the upper cover.



4. REMOVE TRANSPONDER KEY AMPLIFIER


    G034347E02
  1. Using a screwdriver, widen the claw attached to the upper bracket by approximately 1.0 mm (0.039 in.).

  1. Pull out the transponder key amplifier with the claw open.

  1. Disconnect the connector and transponder key amplifier.