FRONT POWER SEAT MOTOR ASSEMBLY (for Rear Lifter) > REMOVAL |
| 1. REMOVE FRONT SEAT ASSEMBLY |
| 2. REMOVE RECLINING POWER SEAT SWITCH KNOB |
![]() |
Apply protective tape around the front seat cushion shield.
Using a screwdriver, detach the 2 claws and remove the reclining power seat switch knob.
| *1 | Protective Tape |
| 3. REMOVE SLIDE AND VERTICAL POWER SEAT SWITCH KNOB |
![]() |
Apply protective tape around the front seat cushion shield.
Using a screwdriver, detach the 4 claws and remove the slide and vertical power seat switch knob.
| *1 | Protective Tape |
| 4. REMOVE FRONT SEAT CUSHION SHIELD RH WITH FRONT INNER NO. 1 SEAT CUSHION SHIELD RH |
![]() |
Remove the 2 screws.
![]() |
Remove the 3 screws.
Detach the claw and guide.
Remove the front seat cushion shield RH with the front inner No. 1 seat cushion shield RH.
| 5. REMOVE FRONT POWER SEAT SWITCH RH |
![]() |
Remove the 3 screws.
Disconnect the connector and remove the front power seat switch RH.
| 6. REMOVE FRONT SEAT INNER CUSHION SHIELD RH |
![]() |
Remove the screw.
Detach the claw and guide.
![]() |
Pull the front seat inner cushion shield RH to detach the claw and remove the front seat inner cushion shield RH.
| 7. REMOVE FRONT SEAT INNER BELT ASSEMBLY RH |
Disconnect the connector and detach the 3 clamps.
![]() |
Remove the nut and front seat inner belt assembly.
Remove the buckle cover.
| 8. REMOVE FRONT SEAT CUSHION COVER WITH PAD |
![]() |
Remove the hog rings.
Bend the 2 front seat cushion frame claws upward.
Detach the hooks and remove the front seat cushion cover with pad.

| 9. REMOVE POWER SEAT MOTOR ASSEMBLY (for Rear Lifter) |
w/o Front Seat Side Airbag:
Detach the 2 wire harness clamps.
w/ Front Seat Side Airbag:
Detach the 3 wire harness clamps.
Detach the 4 clamps indicated by the arrows in the illustration and remove the seat cushion spring.

| *A | w/o Front Seat Side Airbag | *B | w/ Front Seat Side Airbag |
![]() |
Remove the 4 bolts and seat cushion frame.
![]() |
Using a T40 "TORX" socket wrench, remove the 2 "TORX" bolts for the tilt rod.
Remove the nut and tilt rod.
![]() |
Disconnect the connector.
Using a T40 "TORX" socket wrench, remove the "TORX" bolt for the adjust screw.
Using a 4 mm socket hexagon wrench, remove the 2 bolts and power seat motor assembly (for Rear Lifter).
| *1 | Adjust Screw |