Home › BODY ELECTRICAL › LIGHTING › HIGH INTENSITY DISCHARGE HEADLIGHT BULB

HIGH INTENSITY DISCHARGE HEADLIGHT BULB > REMOVAL

for Preparation Click here


CAUTION:
Make sure that the headlight control ECU sub-assembly LH is not connected or hot before removing the headlight control ECU sub-assembly.

HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



3. REMOVE HEADLIGHT CONTROL ECU SUB-ASSEMBLY LH


    E225378
  1. Disconnect the connector.

  1. Turn the headlight control ECU sub-assembly LH in the direction indicated by the arrow in the illustration and remove the headlight control ECU sub-assembly LH.

    NOTICE:
    Make sure that the headlight control ECU sub-assembly LH is not connected or hot before removing the headlight control ECU sub-assembly LH.



    E225379
  1. Turn the headlight control ECU sub-assembly LH socket in the direction indicated by the arrow in the illustration and disconnect the headlight control ECU sub-assembly LH socket.

    NOTICE:
    Do not pull the headlight control ECU sub-assembly LH while the socket is connected.



4. REMOVE DISCHARGE HEADLIGHT BULB


    E225380
  1. Release the set spring lock as shown in the illustration and remove the discharge headlight bulb.