Home › SECURITIES › ENGINE IMMOBILISER › ENGINE IMMOBILISER SYSTEM

DTC    B279C    Theft Deterrent System Presence Detection

for Preparation Click here


DESCRIPTION

If an ECM that is incompatible with the engine immobiliser system is installed, the ECM stores this DTC.

DTC Code
DTC Detection Condition
Trouble Area
DTC Output Confirmation Operation
B279C
An ECM that is incompatible with the engine immobiliser system is installed (1 trip detection logic*).
ECM
Check for DTCs.
  1. *: Only output while a malfunction is present.

Vehicle Condition and Fail-safe Operation when Malfunction Detected 
Vehicle Condition when Malfunction Detected
Fail-safe Operation when Malfunction Detected
Engine cannot be started.
-

Related Data List and Active Test 
DTC Code
Data List and Active Test
B279C
-

INSPECTION PROCEDURE

NOTICE:
  1. When replacing the ECM, refer to the Service Bulletin.
  2. After performing repairs, perform the operation that fulfills the DTC output confirmation operation, and then confirm that no DTCs are output again.

1.REPLACE CURRENT ECM WITH PROPER ECM
  1. Replace the current ECM with the proper ECM.

    1. for 1KD-FTV: Click here
    2. for 2KD-FTV: Click here


NEXT

END